XPROG 6.26 Add New Authorization Xprog ECU Programmer Tool Auto ECU Chip Tuning Programmer

XPROG V6.26:

Software V6.26 Firmware V5.9

Please Attention For Xprog V6.26 Software Installation Tips:

1. Please use the real WIN 7 64BIT system and close the anti-virus program.

2. Only one xprog version 6.26 software can be placed and installed in the computer, no other xprog software, if there are other software, it will conflict and cause certificate problems!

3. Turn on the computer network, the computer time needs to be consistent with the local time.

4. The computer needs to have 2 or more partitions, such as C and D disks. It cannot be an external hard disk, but must be multiple partitions of the computer's hard disk.

5. MUST first install 6.26 registry, then run V6.26 Software.

6. The product cannot open multiple software interfaces at one time, which will cause the product to enter a locked state! ! Because the system will mistakenly believe that you use the product incorrectly or crack the product, resulting in lock-up.

7. Product can't be updated.

8.After used,close the software and unplug the usb dongle from the computer.

Please must follow this instructions to run software,otherwise device will not installed.
Please MUST READ This :

1. Which XPROG version you use , before open software MUST install the right version registry. Otherwise it will runs old version registry automically and then confilt with new hardware and device dead.

2. If your computer no install other old xprog version,it also require install right registry ,otherwise device runs fault and defective .

Skype： bowshine@outlook.com

Wechat: 18098983455

Whatsapp: +86-18098983455